Revision Date: 2005-09-06
| The technical difference is that the 6 sigma used for the Cp calculation (or the 3 sigma used for the Cpk calculation) comes from the estimate of sigma based on the average range, and the 6 sigma used for Pp calculation (or 3 sigma used for the Ppk calculation) comes from the estimate of sigma based on using all the data and the classical formula for the standard deviation. The formulas are available at http://www.pqsystems.com/kb/category.php?catId=61
In general, if the process is in control and normally distributed (standard assumptions when doing capability analysis), both values should be close. However, since most processes wander around a little bit (and are in control), an intuitive interpretation is that the Cpk is what you could be doing and Ppk is what you are doing.
Gordon Constable Ph.D. | |
0%
