PQ Systems Knowledge Base

Category » Device Specific Settings

There were 6 articles found in this category:

1. PS: MUX-10
   Revision Date: 2005-09-19 Baud rate = 1200 (dip switch #3 ON/down, #4OFF/up) Data bits = 7 Stop bits = 1 Parity = Space Control = None RTS = Enabled Comments: If no data comes across, make sure that the cable from the MUX-10 goes to the COM port of the PC and not the parallel port. Ref # 480
2. PS: Smart Cable
   Revision Date: 2005-09-19 Baud rate = 9600 Data bits = 8 Stop bits = 1 Parity = None Control = None RTS = Enabled Comments: Host Command/Request string= R1[13] Ref # 481
3. PS: Mitutoyo Input Tool Model 264-007, IT-007R
   Revision Date: 2005-09-19 Baud rate = 2400 Data bits = 8 Stop bits = 1 Parity = None Control = None RTS = N/A Ref # 497
4. PS: Starrett micrometer
   Revision Date: 2005-09-19 Baud rate = 1200 Data bits = 7 Stop bits = 2 Parity = None Control = XON/XOFF RTS = Enabled Comments: There is a difference between these settings and those of Starrett micrometer 721B. Ref # 482
5. PS: Miutoyo's DT-10 Digimatic Data Transmitter and DL-10 Data Logger
   Revision Date: 2005-09-19 Baud rate = 1200 or 2400 Data bits = 8 Stop bits = 1 Parity = None Control = None RTS = Enable Initialization String (IS)= S1A0100[13] Request String (RS) = Blank Note: The DT-10/DL-10 can only transmit one set of characteristic data at a time into PORTspy. Therefo ...
6. PS: Starrett micrometer 721B
   Revision Date: 2005-09-19 Baud rate = 4800 Data bits = 7 Stop bits = 1 Parity = Space Control = None RTS = Enabled Ref # 504